IMEI
*#06# - International Mobile Equipment Identity
Firmware
*#0000# (new Phones), *#6110# (6110),
*#3110# (3110), *#170602112302# (2110e/i),
*#682371158412125# (new
2110e/i), *#9999# (6160),
V 4.01 - Software version
23-09-98 - Date of
software release
NSM-1 - Type of the phone
Some Examples:
Nokia 1610: V4.19
Nokia 1611:
V4.03
Nokia 2110: V5.31
Nokia 3110: V7.32
Nokia 3210: V3.01
(10/06/99)
Nokia 5110: V5.20 (??/??/99)
Nokia 6080: V4.80
Nokia
6081: V5.14
Nokia 6110: V5.31 (18/02/99)
Nokia 6150: V5.16
(22/06/99)
Nokia 8810: V4.05 (26/11/98)
Service Menu
Enter *#war0anty# (*#92702689#) for
a new menu:
1: Serial Number (IMEI)
2: Production Date (MM/YY)
3:
Purchasing Date (MM/YY). You can enter the date here only once! - So be
careful...
4: Date of the last Repairment (0000 = there hasn't been a
repair)
5: Transfers User Data to another NOKIA phone.
Display Business Card
Menu 2-7-2-1: Set this to
anything you like. Then set the phone cost unit to 1 and the cost limit to
your phone number. Rename a profile to your name and activate it.
Activate Headset/Car Profiles (61xx)
Connect
pin-out 1 and 2 (in front from the right). The LCD displays "headset".
Do
the same with pin-out 2 and 3 and the LCD displays "car".
Call Quality
*3370# Activate EFR
#3370#
Deactivate EFR
*4720# Activate HR
#4720# Deactivate HR
If you want
to increase call quality/decrease battery life enter *3370# (undo with
#3370#).
To decrease call quality/increase battery life enter *4720# (undo
with #4720#).
Profiles
If you quickly want to activate another
profile press ON/OFF. ON/OFF again for
choosing a profile - activate it by
holding ON/OFF.
Check,Activate or Remove card restrictions
#pw+1234567890+1# - Provider-Lock status
#pw+1234567890+2# - Network-Lock
status
#pw+1234567890+3# - Provider(???)-Lock status
#pw+1234567890+4# - SimCard-Lock status
1234567890 (master code) is a 10
digit code, based on the IMEI number of your phone.
Press * many times for
"p" and "w".
Network Monitor (61xx)
This is a hidden menu in
your Nokia Phone. If you want to active it you'll have to reprogram
some
chips inside of your phone. For example the Nokia 6110 Network Monitor:
1.
Check your Software version. You can continue ONLY if you have 4.33, 4.73 or
5.24!
2. Take apart the phone.
3. Desolder the EEProm (ATMEL AT
24C64).
4. Read out the data with an EEProm progammer and save it to a file
(backup).
5. If you have v4.33 or 4.73 then change adress 03B8 from 00 to
FF.
6. If you have v5-24 then change 0378 from 00 to FF.
7. Write the
new data to the EEProm and solder it back into the mobile phone.
8. Power
on your phone and you should have menu number 10.
The Network Monitor gives you the following
informations:
· [ Carrier number
· [ MS RX level in
dBM
· [ Received signal quality
· [ MS TX power level
· [ C1 (path loss criterion, used for cell selection and reselection).
The range is -99 to 99
· [ RLT (Radio Link timeout)
· [
Timeslot
· [ Indication of the transmitter status
· [
Information on the network parameters
· [ TMSI (temporary Mobile
Subscriber Identity)
· [ Cell Identification (CELL ID, number of the
cell being used)
· [ MCC (Mobile Country Code)
· [ MNC
(Mobile Network Code)
· [ LAC (location Area Code)
· [
Ciphering (on/off)
· [ Hopping (on/off)
· [ DTX
(on/off)
· [ Discarding cell barred information
Another way for activating the Nokia Network Monitor
Menu:
All you need is PCLocals (a simple DOS program) and a data cable
(like the one from the Nokia Data Suite). Then follow the instructions...
Ring Tones Upload
...to Sonera:
http://www.sonera.fi/nmt-gsm/doris/
...to Denmark, Iceland, Norway or
Sweden: http://www.exigo.se/nokia/nokia_ringtones/
...to all networks:
http://www.rf.nokia.co.za/ring/ringtones.html
Sim Clock
*#sim0clock# Shows whether your
SIM-Card supports clock stopping or not.
Fast Silent Mode
Press MENU and then # (Nokia
3110 - v7.11 and later).
Caller ID (2110)
If you want to enable Caller ID,
enter *#30# [OK], to enable Call-Blocking enter *#31# [OK].
This options
are not yet available in most areas!
Cell Sites (2110)
[MENU] 4-9-1: Enable display of
cell-site names.
Shortcuts
· If you quickly want to
activate another profile press ON/OFF. ON/OFF again for choosing a profile
and hold hold ON/OFF for activating.
· Press 1#, 2#, 3#,... to get
the entry stored at this location in the phonebook.
· You can access
the Call Menu, that is normally only available during a call, by pressing
and
holding the MENU button (61xx).
· Press and hold # while you
are in the phonebook to the phone number (51xx).
Pin-Outs
Nokia 16xx, 31xx, 81xx:
TOP OF
PHONE
1 2 3 4 5 6
(O) # [= = = = = =] #
7 8 9 0 A B
1 - GND
6 - M2BUS
Programming Mode (6160)
*3001#12345# allows you
to enter the larger programming mode (NAM1, NAM2, NAM3, Security Code
changes, allowed emergency phone numbers, the Service Menuand finally the Field
Test Mode.
What is WinTESLA?
Nokia TEst and Service
>Locals >A>pplication.
Nokia Snake |
